Description

The ControlByWeb X-DTHS-P is a new temperature and humidity sensor probe and used in conjunction with many of the 400-Series, X-600M, and WebRelay-Wireless products. Temperature and humidity are accurately measured, digitized, and sent to the ControlByWeb module over a serial 1-Wire Bus.

One or multiple sensors can be attached to the 1-Wire Bus and its cables can be extended up to 600 feet (approximately 182 Meters) from the module without any loss of measurement accuracy.

The X-DTHS-P comes with two mounting options:

Mounting Clip – For ease of mounting against a surface. Thru-Wall Mounting Bracket – For HVAC duct monitoring. The bracket has a foam gasket to seal the access hole.

The sensor is able to be installed outdoors but must be protected from the elements. Insure that you install the sensor in a protected location away from rain or direct sunlight.

No additional software, or power supply required. Simply connect and set up on any of our compatible products.

Temperature Sensor Wiring & Mounting

The sensor has three wires which are connected to a compatible ControlByWeb device on the 1wire Bus. The cable can be extended with additional wire if needed (182M max).

Features

• Temperature Range: -40°C to 80°C (-40°F to 180°F)
• Temperature Accuracy: ±0.4°C (typ 0°C to 80°C)
• Humidity Range: 0-100% RH
  • (Not suitable for environments with reoccurring or prolonged condensation)
• Humidity Accuracy: ±2%
• Type: Digital 1-Wire
• Lead Length: 10ft (3.04m)
• Probe Length: 3.92in (99.6mm)

Compatible Products

• X-400
• X-400C
• X-404
• X-404C
• X-405
• X-406
• X-410
• X-420
• X-600M
• WebRelay Wireless