600M Expansion Bus Power Injector
Expansion Bus Power Injector
Use with a ControlByWeb Expansion Cable when there is a large number of expansion modules being used and additional current capacity is required
The X-PINJECT DC power injector has two ribbon cable connectors and a connector for supplying 9-28Vdc to the expansion bus separately from a X-400 or X-600M controller to power additional expansion modules.
- Description
- Compatible Products
Description
Overview
The ControlByWeb X-400 or X-600M controllers can only provide up to 1.7 Amps for powering any associated expansion modules. Hence in applications where a large number of expansion modules are used that would normally exceed this current limitation and where additional current capacity is needed, a DC power injector can be employed to power the next set of expansion modules.
The CBW Expansion Bus Power Injector has two ribbon cable connectors and a connector for supplying power to the expansion bus separately from an X-400 or X-600M controller.
The communication signals pass-thru the power injector but the DC power from the X-400 or X-600M does not. The power injector thus provides the additional power for all of the expansion modules to the left side of the injector. The ribbon cable itself can only carry 1.7Amps maximum. Install one or more power injectors such that no portion of the ribbon cable exceeds 1.7Amps.
Note: It is recommended to power a X-400/X-600M controller and power injectors using the same power supply.
ControlByWeb Compatible Products
- Expansion Cable for the X-600 Series
- Expansion Cable for the X-400 Series
